i recently bought a peugeot metal-x moped and found the front wheel to be a bit loose i was wondering if anybody could give me a rough guide as to how to tighten it. the wheel slightly turns bout an inch or so away from the handle bars i don think its a big job i just need to no wat i need to tighten it thanx
You should contact your local vet hun and find out what is going on with the eggs,that could be something seriously wrong with the eggs.Good luck
there must be 3 bolts that could want tightened, 2 that carry the column as much as the sprint, you will could desire to take the plastic piece under the guidance column off after which you will see the two bolts retaining the column to the sprint and the different bolt is obvious on the backside of the guidance column suitable on the firewall on the interior the vehicle, that is referred to as a pinch bolt and it holds the guidance onto the guidance rack it is on the exterior of the firewall, make optimistic that bolt is tight.
Frist i would remobe the axle and bearing clean them up, and instect for damage. If tyhey are o.k. pack with wheel bearing grease and re-install. Tighten down untill the wheel begind to drag, back off untill cotter key hole will line up , with wheel spinning freely.
if its the wheel its self, then remove split pin on spindle then tighten the nut if nut is tight you can not see any gap between the hub forks check berings by uting bike on stand then with one hand hold top of wheel the other bottom of wheel now push withone hand pull with other vice versa if wheel wobbles you have faulty wheel berings
