Time switch how to adjust the time
Microcomputer control switch is a single microprocessor as the core with electronic circuits and other components of a power switch control device, can be days or weeks of circulation and multi-time control of home appliances opening and closing. Time set from 1 second to 168 hours, can be set daily 1-4 group, and multi-channel control function. One setting is valid for a long time. Applicable to all kinds of industrial electrical appliances, household appliances, automatic control, both safe and convenient and save money. The output current can be 10-25A, both normal control 2200W to more power of electrical work. But also with the relay, contactor, and other control of a variety of other high-power power equipment.
Set up relatively simple,
Such as setting the load for an open time 18:00,
The time is 05:00
Set the method as follows,
A time for the 18:00, a set off 05:00, two open two off three open three off until ten open ten off the time to clear the time (because less than). And then set a good week, set the current time control switch, the time switch to automatically switch.
The specific operation can refer to the instructions to set, very simple. Try it out a few more times.
Microcomputer time control switch timing setting
1. Check the clock display whether the current time is consistent, if you want to recalibrate, while holding down the "clock" key, respectively, hold the "school week", "school", "school" key, the clock transferred to the current accurate time;
2. Press the "Time" button, the bottom left of the display appears "1 open" words (that the first time to open). And then press the "school week" to select the six-day work system, five-day work system, three days of work, the same daily, different daily work mode, and then "school", "school" key, time;
3. Press the "time" button, the bottom left of the display appears "1 off" words (that the first off time), then "school week", "school", "school" key, enter the required The date of closure (note: the date must be related to the opening date) and time;
4. Continue to press the "timer" button, the lower left of the display will display "2 open, 2 off, 3 open, 3 off, ........, 10 open, 10 off", refer to step 2, 3 set the subsequent switching time;
5. If you do not need to set 10 groups of switches every day, you must press the "Cancel / Resume" button to erase the time of the remaining groups to display the "- -: - -" pattern on the display (not 00:00)
6. After the timer is set, press the "timer" button to check whether the timing setting is consistent with the actual situation. If it is not the same, please adjust the school day, school, school week to adjust or reset;
7. After checking, press the "clock" button, so that the display shows the current time;
8. Press the "Auto / Manual" button to set the "▲" symbol below the display to the "Auto" position. At this time, the time and space can be turned on and off automatically according to the set time. If you want to use the process of opening and closing the circuit, you only need to press the "automatic / manual" button to "▲" symbol to the corresponding "open" or "off" position.
