Home > categories > Machinery & Equipment > Lift Tables > Seven tons of lift should be fitted with the straight screw and motor
Question:

Seven tons of lift should be fitted with the straight screw and motor

To make a four trapezoid screw lifting up seven tons of lifting platform should be matched with the straight screw and motor

Answer:

Force teck can offer the synchrolifting lifting system design, a full set of accessories combination: spiral elevator, commutator, drive shaft, shaft coupling, gear motor, as well as the system, a full set of CAD drawings, and the scene debugging
Can be judged according to the accuracy requirement of lead screw grinding or rolling, depending on the load and its acceleration can choose servo power right away and screw the maximum load capacity (do longer engineers can intuitive judgment the diameter of the screw and large), so that you can around the power of the servo motor of the different speed and different lead screw to match, so there will be several different schemes: high speed servo motor with small lead screw (sometimes deceleration machine), big inertia servo with lead screw. Under the condition of the machine cost to determine, from two to three scheme choice, choice of method is to choose low cost, with high stability, cost effectiveness and cost are the same common and suppliers have a spot. If the single from choose the ways of the servo and screw usually have an intuition, like 3000 revolutions of servo goods on the market the most sufficient, screw is according to the supplier's inventory.
A lift platform system, we are doing, you should tell your system speed, accuracy, and so on parameters, can calculate the motor power, speed, lead, lead screw diameter, guide rail, can communicate in detail

Share to: