Home > categories > Machinery & Equipment > Arc Welders > Viva WS-200S dual inverter DC argon arc welding / manual welding of the fault
Question:

Viva WS-200S dual inverter DC argon arc welding / manual welding of the fault

Viva WS-200S dual inverter DC argon arc welding / manual welding of the fault

Answer:

This one is not good for you to say but the fault current general welding instability, arc difficult, crater crater, welding welding, welding penetration to see the book
1. no high frequency2. no load3. start tripping4. boot protection5. unaspirated6. high frequency non-stop7. argon welding, no response by gun8. small current9. spot welding protection10. meter runout11. argon welding, solder joint blackening12. arc break13. boot no response14. fans do not turn or turn to stop
Argon arc welding, the power switch can be welded open, the current is very large, can not be closed, high near the ignition
1. no high frequency2. no load3. start tripping4. boot protection5. unaspirated6. high frequency non-stop7. argon welding, no response by gun8. small current9. spot welding protection10. meter runout11. argon welding, solder joint blackening12. arc break13. boot no response14. fans do not turn or turn to stopBasically all hand soldering / argon welding inverter welding machines are all these problems.

Share to: