Wall is a good paste or paste the good eye
Pure solid wood wall Corolla Paulownia wood 100%, three parts of the area Baked.
I have log installation diagram, you look at
installation method:
1, is to use glass glue (also known as silicone, sealant, building materials stores or hardware stores have sold) directly sticky, glass plastic recommended with a transparent, sticky seems to be better, not for decades. )
2, sticky method is to choose a good position, in the corner of the corner coated with some plastic glass, each point should be thick enough for the job, willing to glue more painted, better sticky
3, but there is a problem to be solved, that is, in the glass gel is not solidified for several hours, it is possible to fall down to solve the problem of the method;
Is the use of thick double-sided adhesive (also called bubble glue, stationery shop, stationery stores, general civilian hardware complex, and some supermarkets have to sell) to assist in the installation, that is, in the corner of the negative, paste some thick double Noodles, and then play some more plastic, so sticky after it will not decline, and so the glass gel completely solidified, it is strong.
Comparison between the two, the corner of the hole than the paste a little better, but the corners of the corridor is generally better way to paste. If the punch by nails, it will damage the jade corners of the grade and beauty.
Paste it, on a corner, space is limited, eyebrows easier to break.
1, paste the corner of the installation method: the use of glass adhesive to the corner, and then seal the edge can be sealed.
2, punching angle installation method:
1) The installation height is adjusted according to the individual aesthetic angle. Recommended height: corner of the corner from the ground 20-30 cm can also be directly to the ground or with the base line flush.
2) first affixed to the wall on the wall, put the required height, and do a good job in the installation hole mark, in order to take the corner after the accurate punching.
3) Please use a drill bit of 5mm adjustable speed hammer drilling, the plastic expansion bolt into the hole.
4) Align the hole on the corner with the hole in the wall, tighten it with the screw, and then cover the buckle and then seal it with the sealant.
