Wash the bottom of the wash basin has been how to repair the water
Take a 520 glue, and an iron stick on the OK to friends
Washbasin water treatment basic steps
1. Take out our basin under the water pipe, the water pipe below the amount of fixed parts and flange removed;
2. In the installation of the basin when the water should pay attention to pick up the basin of the table, the water pipe flange removed, and the water pipe flange on the basin above.
3. After tightening the flange, the basin on the table, the outlet at the exit of the table, in the sewer and the basin of the mouth of the contact surface coated with glass glue, pay attention to uniform and complete to prevent leakage The
Wash basin treatment method
Will be our water pipe at the outlet, flat to put it in, and to note that the installation of the basin must be installed on the water tanker out of the fixed, screwed in the water on the top, but also with a wrench to the water fixed Set tightly. After the installation of the basin water is completed, but also wait for 24 hours after the glass gel dry after it was tested in the basin filled with water to see if there is no leakage of water pipes occurred.
In the installation of drainage before the basin around the basin to fight a glass of plastic re-security, glass gel dry just fine, pay attention to glue can not have water
