What are the components of the curtain wall
(1) glass curtain wall insulation, insulation, fire, airtight, anti-noise, fire, earthquake and other functional requirements, should be in the design, construction should be taken seriously, the construction should be designed according to the requirements.
(2) glass coating side are toward the room; coating shall not scratch and fall off.
(3) aluminum alloy profiles shall not have a greater bending deformation and local crushed deformation, straightness should be less than 0.5 ‰, and the total length of not more than 2mm.
(4) Corbel with iron and embedded in the concrete beam, the cylinder on the T-slot fixed with stainless steel or galvanized screws and nuts; and concrete contact surface shall not have more than 1mm above the gap (this gap can be used steel plate Tight stuffed).
Corbel iron and curtain wall joints are padded with shock pads.
Corbel iron in the three directions of the installation error shall not be greater than ± 1mm.
There is a gap of 200mm between the inner surface of the curtain wall and the beams and columns of the building. Each room has four or so gaps, which are filled with fire mineral wool.
Glass and aluminum frame between the side to be embedded with three claws or four claws of a rubber strip, rubber geometry of the geometric size shall not be too large or too small; unit type curtain wall to be embedded "V" and "W" Cross-section of the wind, waterproof rubber band, tape, tape interface to apply sealant, impaction shall not be omitted. Top and bottom waterproof rubber sheet with adhesive and building structure fixed.
