What are the features of a LED lamp?
LED light source has the advantages of no UV and infrared radiation, and can avoid the pollution of mercury fluorescent tube rupture overflow and other substances, Recyclable waste lamp recycling; LED distributed on the strip plate independently, increasing the volume of light source, beautiful appearance and low cost; through the reasonable arrangement of the strip plate, overcomes the LED light angle limitation, achieves the three-dimensional effect, the lamp light point. The utility model can completely replace the traditional tungsten crystal lamp and energy-saving lamp crystal lamp, the brightness can be comparable with the energy-saving lamp, energy-saving lamp color temperature is easier to control, more energy, crystal lamp can replace the other light source.
The biggest thing about LED is energy saving.The LED crystal lamp comprises a lampshade, a base for fixing the lampshade, a lamp cap positioned at the top of the base, a plurality of circuit boards electrically connected with the lamp head in the lampshade, and LED crystal and crystal arranged on each circuit board.
LED lamp low working voltage, small current, short response time, good seismic performance and impact resistance, high reliability, long service life, can be modulated by the strength of the current to control the strength of the light that is power, not easily broken..
The metal lamp body and the metal plate hanging apart, put back on the side of a metal plate wall screw rod and the lamp body metal chassis hole set balance, tighten, and served as the "out of" into action to test whether we can easily, easy installation steps after; and the metal hanging plate to tune with smallpox parallel and diagonal parallel installation, in order to achieve the aesthetic effect, and must ensure that the firm is installed in the ceiling; 2, the transport process or during the installation process may be all LED light pressure in a concave inside the lamp body top back, so as not to affect the 3, there is no need to check the lamp fittings or screw like installed in the back the lamp body (usually organic glass accessories, glass rod is used to support the landlord), and ensure the correct installation of fixed, the rest can be temporarily outside the ornaments do not need to install. 4, the installation of lamps, if the lamp is equipped with remote control device, we must distinguish between the fire line and the zero line, otherwise cannot be energized or easy to burn up; when the lamp body prepared with metal hanging plate is connected to the LED note the position of the light source, LED light source will affect the sag effect; 5, fixed to the ceiling when power on to test whether the power is normal, then put the rest on the surface of the lamp body parts installed on the steps.
