What is the cause of the motor speed reducer slipping?
I. the connection between the gear shaft and the reducer of the motor, the tooth surface is flat or the tooth surface is broken.Two, the speed reducer output shaft part, there will be a small output shaft and gear reducer internal connection, the key may be broken, resulting in motor operation, the output shaft without slippage.
Motors are called motors. As the speed of the motor is too high, it may be necessary for some mechanisms to be used after deceleration. At this point, you need a reducer. Now the general use of reducer is gear reducer, that is, the two gear meshing, according to the line speed is the same, but the angular speed of the principle of different slow down.
Two reasons:I. the connection between the gear shaft and the reducer of the motor, the tooth surface is flat or the tooth surface is brokenThe two part, the output shaft in the reducer, there will be a small output shaft and gear reducer internal connection, the key may be broken, resulting in motor operation, the output shaft without slippage
