What is the difference between tempered glass shed and tempered glass and canopy sunshine shed?
Is the same, because we must consider the safety factors, with less ordinary glass, commonly used is tempered glass and laminated glass.
There are also a PC sunshine board, PC Nai Liban, whether it is light transmission, insulation, safety, service life, appearance, cold bending performance, better than the glass, but the cost of It is slightly higher!
Light steel glass canopy before dispensing attention to clean the glass, particularly glass edge position at the junction with the gum to avoid secondary pollution, good wind site measures to avoid the influence of the glass plate deformation in structural adhesive curing process. In the process of filling the glue to ensure that the vertical and horizontal joints at the smooth interface, filling the seam, no spill, burr and other phenomena
Light steel glass canopy focus on just the material for the light steel, tempered glass canopy focus on the glass material for the tempered glass, are glass canopy, but the name of the focus is not the same, light steel glass canopy glass can also be used Glass ah
The loads of light steel canopy include the weight, wind load, snow load and live load, in which the snow load is not taken into account, the wind pressure is positive or negative, a certain range of negative pressure is beneficial to the structure, the actual calculation Considered separately. Through the comparison, the design and calculation of the most unfavorable conditions of the combination of the dead weight, the wind load and the live load are carried out, including the calculation of the force combination of the glass and steel glass sheds, the calculation of the glass strength and the checking of the glass deflection, and finally the selection of the material The
In the light steel glass canopy glass plate drilling processing, the connection part of the support device in advance openings, add water seal ring processing, to avoid the site to produce a higher stress concentration. Light steel glass canopy should be wiped clean before the surface, and according to the weight of the glass to determine the reasonable number of suction cups to ensure the safety of construction. By connecting the jaws to connect the glass, the installation should be checked before the glass drilling and splicing claws connected to the casing position, and timely adjustment. After the glass is fully installed, check the flatness and verticality of the light-glass glass canopy, the glass seam, and the width of the light-glass glass canopy to meet the needs of the shed in the temperature change and the structural displacement. Touch the request at the same time in the seam when the tensile deformation of their own to meet the temperature changes and structural lateral displacement of the joints to widen the requirements.
