What is the manual pre assembly procedure for the EO-2 joint?
4, the pre assembly force should not be too ambassador, the inner edge of the card sleeve is just inserted into the outer wall of the pipe, and the clamping sleeve should not have obvious deformation. When the pipeline connection, and then according to the specified tightening force assembly. Phi 6-1 card sleeve tightening force is 64-1 15N, 16 MMR 259n, Phi Phi 18mm for 450n. If the sleeve is badly deformed at pre assembly, it will lose its sealing effect.Matters needing attention：1, prohibit adding sealant and other fillers. Some people in order to obtain better sealing effect, in the card cover with sealant, the result of sealant is poured into the hydraulic system, causing hydraulic components, such as plugging holes.2. When connecting the pipe, should make the pipe has enough deformation allowance, avoid the pipe by tensile force.3. When connecting the pipeline, it should be avoided to be subjected to lateral force, lateral force caused by the assembly seal is not strict.4, when connecting the pipeline, should be a one-time good, avoid repeated disassembly, otherwise it will make poor sealing performance.
I. pre assembled1, EMB card sleeve type pipe joint pre assembly of the most important link, directly affect the sealing reliability. A dedicated preprocessor is usually required. The small diameter can be pre joint in a vise. The concrete method is to use a joint as the mother's body and press the nut and the sleeve onto the tube. The utility model mainly comprises a sleeve type through pipe joint, a clamping sleeve type end through connection head, a clamping sleeve type three way pipe joint and other patterns. I found that even if the same manufacturer of a batch of goods, the cone of these joints on the depth of the hole is often different, resulting in a leak, and this problem is often neglected. The correct approach is to connect the end of the pipe with what kind of joint, and the corresponding connection ends are prefabricated with the same type of joint, so that the leakage problem can be avoided to the maximum extent.
I. pre assembled1, EMB card sleeve type pipe joint pre assembly of the most important link, directly affect the sealing reliability. A dedicated preprocessor is usually required. The small diameter can be pre joint in a vise. The concrete method is to use a joint as the mother's body and press the nut and the sleeve onto the tube. The utility model mainly comprises a sleeve type through pipe joint, a clamping sleeve type end through connection head, a clamping sleeve type three way pipe joint and other patterns. I found that even if the same manufacturer of a batch of goods, the cone of these joints on the depth of the hole is often different, resulting in a leak, and this problem is often neglected. The correct approach is to connect the end of the pipe with what kind of joint, and the corresponding connection ends are prefabricated with the same type of joint, so that the leakage problem can be avoided to the maximum extent.
