Home > categories > Mechanical Parts & Fabrication Services > Gears > What is the range of the gear ratio of the two stage helical gear reducer?
Question:

What is the range of the gear ratio of the two stage helical gear reducer?

What is the range of the gear ratio of the two stage helical gear reducer?

Answer:

The transmission power is big reducer best dual drive type or drive center. This two kinds of layout can be composed of two pairs of gear pair share the load, is conducive to improving the stress condition and reduce the transmission size. The driving gear drive design of double drive type or center, should try to take the automatic balance device of gear pair the load can obtain uniform distribution, such as the use of sliding bearing and elastic support. The cylindrical gear reducer with involute and circular arc tooth shaped two categories. Besides the different tooth shape, the structure of the reducer is basically the same. The transmission power and transmission ratio is same, arc gear reducer in the direction of the length of size than involute the gear reducer is about 30%.
2) input torque should be far from the gear shaft, in order to reduce the uneven distribution of load along the tooth width; 3) using helical gear arrangement, and the loading of large low level and located just between two bearings, so the load distribution along the tooth width obviously than the expansion. The high speed gear of the reducer the commonly used helical gear, one side is left-handed, the other side is right, the axial force can offset each other. In order to make about two of the gear can be automatically adjusted to equal the load transfer, the lighter axle should be able to do a small walk in the axial direction. The coaxial reducer input shaft and the output shaft in the same axis therefore, the body length is short. But this kind of reducer the axial dimension of the cylindrical gear reducer. In all the most widely used device. Deceleration transmission power can range from small to 40 000kW, the circumferential velocity can also be from a low to a 60m/s 70m / s, even up to 150m /
When the transmission ratio is below 8, the single cylindrical gear reducer. More than 8, the best selection of level two (i=8 - 40) and grade two (i>40) of the reducer. Single stage reducer transmission ratio is too large, the overall size will be large. The type of transmission two and more than two cylindrical gear reducer with expansion, split and coaxial number. Expansion of the most simple, but not because of bearing gear on both sides of the symmetrical arrangement, which will make the load along the tooth width and the distribution is not uniform, so that both sides of the bearing force range. Therefore, in the design should pay attention to this reducer: 1) shaft stiffness should be bigger;

Share to: