What kind of glass magnesium board?
Paint decoration: you can use spraying, brushing or roller coating, but brush must see the paint when the instructions.
? Decorative surface tile: in the bathroom, bathroom, kitchen, basement, and other wet areas installed, the need for tile in the board between the distance between the keel must be shortened to 400MM. Each wall of the wall (about 3.6 meters) must be left with an expansion joints.
People and purification for you to introduce glass magnesium board wall use and precautions
(1) plate: under normal circumstances with the recommended thickness of more than 8mm glass magnesium board to do partition board.
(2) Accessories: 6MM above the plate fixed frame on the keel, the use of 3.5200MM Shenzui galvanized screw fixed, nail head below the board 0.5MM, in order to ensure the finishes flat.
(3) installation: start the installation, you must mark the exact location of the keel, and make a mark. Vertical keel center distance Wei-450-600MM, the wall of the connection and doors and windows on both sides of the installation to install additional keel, such as wall height greater than 2440MM, the need to install the plate at the connection to support keel.
(4) Board distance: between the plate to stay between the distance 4-6MM, between the plate and the ground must be left 3MM-5MM gap, screw installation center distance of 150MM, from the board edge 10MM, from the corner angle 30MM.
Sound insulation wall: If the wall has a higher sound insulation effect, must be required to close the wall and the board tightly closed, and then fill the hollow wall of mineral wool, such as the keel on both sides with two different thickness of the board, the sound insulation better The
? Impact wall: It is recommended that you use 12-15MM above the plate with a long screw reinforcement.
This method can enhance the impact resistance, heat insulation, sound insulation and fire performance.
Hanging: bathroom or kitchen hanging heavy objects, must be reinforced with wood or keel, so as not to damage the plate.
? Seam processing: in the installation of sheet metal and sheet left gap 4-6MM, with 107 glue or strong glue and mix thoroughly after the use of scraper plate and cracks, and then with the grid with a paste flattened.
