Who knows the installation method of woodworking planer?
The weight is bent, the installation is installed in the plane above the rail pressure, inner surface on the planer tool, thread is in pressure prominent iron outer bending surface, does not affect the use of theTake a closer look at the picture below
And a small piece of wood stuck!My father used to be a carpenter. I saw moreSmall pieces of wood should be along with the size bladeSmall wood chip to Guanghua, how can the network even sold together with wood chips?Pressure mounted on the iron screw, and cutter together edge alignment, lies in, pressure in iron, into the plane, again on a wooden wedge.
The first tool to grind straight, add every cutter are put into the slot, the blade exposed a little longer, to keep the axis can be rotated to eight screws tight, with a ruler in a flat after the planer panel, close the panel, the ruler is placed in a plane opening, reverse rotation axis. If an edge is higher than that of the panel, beating the blade with wooden hammers, and both ends of the three intermediate point adjustment, until every edge three points just grazed the ruler, the blade and the plate height to tighten the screws on the line.
