What's wrong with a wood plate bent out of a cold press? Board 2 meters long, 15 centimeters wide, a pressure of 7, tile solution!!I use a cold press, not a hot press.
50 tons of wooden board cold press to have, but can not go down, the pressure relief valve has been replaced with new, or no, what's the problem? It has been submitted once!
This has to do with the glue, the pressure, and the stress of the material, and the temperature of the season
Are you pressing rough ah, in under the pressure of the process while pressing, the other side is not pressed, which requires you to adjust between the compressor and compressor bottom level, I do not know your press or worm is hydraulic, hydraulic take it, loosen the synchronization rod, the compressing plate down. In the bottom and flatten the synchronizing bar by the rack on both sides of the lock,
