woodworking computer engraving machine, how can you figure?
1.: when the load has to suspend processing files, if the system is in the idle state, press this button, the system starts running processing procedures; if the system has been in the processing state, press this button, the system to suspend processing.2. stop: stop the current operation. If the system is in the processing state, press this button to stop processing; if the system is in a floating tool state, press this button to stop the floating tool3. breakpoint continues: if the system is in the processing pause state, press this key, the system starts processing at the breakpoint
Woodworking machinery. The three control modes: one is all the operation control is completed by computer, computer engraving machine at work in the work of the state, unable to carry out other typesetting work, waste may be caused by the misoperation of the computer; two is the use of single-chip control, the engraving machine can work at the same time the layout, but not closed the computer, the computer can reduce the errors caused by the waste; three is the use of USB port data transmission system has more than 32M of memory, save the file to be completely separated from the computer, turn off the computer or other layout, can greatly improve the working efficiency.
5. spindle switch: if the spindle is closed, press the key to turn on the spindle; otherwise, turn off the spindle6. returns the origin: press this key, and the system executes the origin command to the workpiece7. x 1: press this key to set the inching step to 0.01mm.
