I have an 04 saturn l300 and when I get up to 70 mph + the car shakes really really bad to where stuff is rattling. Lower speeds is more controllable. I have new tires put on and balanced but still shaking bad. Also new break pads and rotors were put onAny suggestions?
a bent axle can cause that but you would noticed it at low speed too ! did you check the ball joints and tie rods ? the rattle could be the bushings worn out in the sway bar !
L pipe is typically used for domestic hot water use since the copper tends to pit internally due to acidic water. M can be used for domestic and is allowed by code in most areas. However, it's the sign of a cheap installation. M is ideal for hydronic systems since it is the least expensive and in a closed system will not corrode.
you in all threat have a bad tire with a broken belt. A severe velocity vibration above 50 mph in many circumstances point out a tire stability concern. If there's a badly worn or unfastened factor interior the suspension you will additionally get this vibration. bypass to any tire save the place alignments may well be executed to have the vehicle regarded at. sturdy success
A bent axle shaft could do that, but it's a very unlikely cause. It's more likely worn out struts and shocks.
k---- thick walled pipe usually only for certain industrial applocations L---medium walled---used on homes etc for water supply lines -hot and cold water-baseboard heating--etc M---thin walled pipe used also like type L but cheaper. Home Depot stuff. DWV-- drain, waste, and vent. Used as the name implies. Not for water supplies----only drains----very thin. comes in sizes from 2 1/4 and larger. A-- not familiar with this one.
