Home > categories > Security & Protection > Heat Detector > Would you approve of a federal shield law for journalists?
Question:

Would you approve of a federal shield law for journalists?

The Senate Judiciary Committee approved legislation Thursday to establish a federal shield law for journalists, but it faces obstacles to Senate passage.The panel voted 15-2 to approve the bill (S 2035) by Arlen Specter, R-Pa., after grappling with several amendments offered by Jon Kyl, R-Ariz. The committee adopted some of Kyl’s amendments but rejected others.Proponents of the measure say it is necessary to protect reporters who find it difficult or impossible to obtain vital information about official wrongdoing and other sensitive subjects unless they can promise their sources confidentiality. Opponents argue that a federal shield law could hamstring law enforcement officials seeking to prevent acts of terrorism or uncover unlawful leaks of classified information.

Answer:

Yes 3M has a color-stable film but that has a very low heat rejection of 35%
There is no way to answer your question. I will tell what is involved and you can go from there. The reason for the non-answer is the widely varied cost per hour and the cost of service calls. The dishwasher is usually installed next to the sink. You need to tap into the hot water side at the sink faucett(that's under the counter, on the water line that goes to the hot faucett(should be the left side)). This goes all the way from a saddle tap if the line is copper to plumbing in the fitting(should be no more than 1/2 hour labor). The drain will repuire the installation of a new tail piece this is the piece coming out of the bottom of the sink(again, no more than 1/2 hour). The dishwasher will, also, need to have 120vac available. This can be as simple as plugging in the dishwasher(usually that's what is done) to running new wiring with it's own circuit breaker. NOW!, if it's a portable dishwasher you need to: roll it to the sink area. plug it in to a wall outlet, put the drain hose into the sink, attach the water to the sink faucett(there is a special fitting that screws onto the end of the faucett, that can be purchased at Home Depot, hardware stores etc. (less than $3.00) Good Luck

Share to: