What transmission oil do I use. Put new transmissin an clutch and eveything but car shakes when I put in the gear. Plz hlp
at what rpm does this happen at. it could be your engine about to stall out because it is idling too low, and the new clutch could be grabbing your flywheel strong enough for you to notice now, where the old clutch could have slipped in this situation and you might not have noticed. So you could have to clean or adjust the components that make your car idle (idle air control valve and the fast idle valve). Your owners manual should tell you what type of transmission lubricant you should use but I'm pretty sure any manual transmission fluid would be OK, and regardless of the type of lubricant being used this is not a problem that should result from that.
Don't waste your time or money on a cai! You'll only gain maybe 2-3hp above 6000 rpm. Save your money and get one of the handling kits from Maximum Motorsports! (Stangs rock!)
local auto parts store will help. if you have owners manual that will also tell you
There a lot of matters you are able to do with the engine you will have now. Headers an additional addition well you're going there you could as good change the Cat with an aftermarket excessive float cat. For between a hundred and fifty - 200 Skunk2 makes a Vtec and gas controller you could possibly certainly to get anybody to tune it however that you can trade when your vtec responds and and u can develop or curb your gasoline curve. That's just a few suggestions there is a lot extra it all is dependent upon how much money you wish to have to spend or how in-depth you need to get.
It really doesn't matter as they are all pretty much the same. CL seems to be a popular choice but none of it will matter if you dont buy a tuner or get a dyno shop to tune your car. TUNE TUNE TUNE thats what will make the difference, not the filter.
