Accord 9 left door door trim how to split ah?
First find the front switch handle behind a lid, with the weapon to pry it open, the inside of the screw unloaded and then down the armrest also has a lid, the same reason to remove the screw, then look at the right side of the glass edge there is a small Triangle plaque, hand off the edge can be directly removed, no screws, the next step to take a small knife inserted into the door under the edge of the gap, pry open a certain gap with the fingers after the force to break apart, the veneer around Buckle are out, up the trim plate can come up with a little, and then press the door switch handle, so that with the veneer separation, and then pull out the control plug can be.
Tools: flat screwdriver, 8 socket wrench
Steps:
1, with a flat screwdriver down to pry open the door handle lower trim, from the middle down and then pull out (the back door is the pry half of the front)
2, remove the handle under the veneer can be seen after the internal two black eight hex bolts, with a socket wrench down
3, unplug the window lift switch plug (which has a clip, use your fingers from the back hook to pull out)
4, with a flat screwdriver from front to back pry open the door handle trim panels, remove the door when the handle
5, hand the door trim below the mouth a little open a gap, and then put a wrench into the pry, that the interior board is a plastic card with a plastic card buckle on the door, the pry when the time to use a little effort, One by one pry. If you want to wrench the plastic interior trim bad, you can use a little steel bars and the like, but not too thick, or can not reach into.
6, a lap card bamboo shoots all pry open, hold the door trim board can be removed from the bottom up.
