Home > categories > Automotive & Motorcycle > Wheels > After the electric car for the rear wheel of the controller. How to line?
Question:

After the electric car for the rear wheel of the controller. How to line?

After the electric car for the rear wheel of the controller. How to line?

Answer:

You look at the next is a universal controller or supporting the controller on the top of the general written four in one, dual-mode, no Hall and other words. If the omnipotent will have a test line or reverse line detection line is half the same color (do not rule out the color is not the same) are from the controller out of the thin line and can be inserted into a plug like no more to plug a bit. If it is not a universal controller on the inverted cable test it. Of course, sometimes there will be careless master of the reverse line when the brake line connected to a similar situation ... ...
I put the battery car under the line and then loaded up when the wheel suddenly turned back
After the replacement of the controller after the reversal of the motor is the new controller phase into a different phase, the line is very simple to the motor of the three large lines of any motor-side of the three lines this time not only to tighten the thread but also pay attention to the motor sound. There is a way is to adjust the Hall of the signal line is a total of five positive and negative can not move the other three arbitrary transfer is known to turn forward.
The signal line and the motor line at the same time for two

Share to: