Any help greatly appreciated. So I drive a 2005 Chrysler 300. 3.5l v6. I have strange headlight and tail light issues. Mind you there are what I believe aftermarket LED halo style headlights in the front. Tail lights are from 300c hemiFirst of all my #8 fuse [15 amp] is repeatedly blowing for no appearant reason. A Working fuse gives me the fancy blue halos, orange lamps, 3 small LED's and my normal beams. As well as proper running tail lights for the back and a responsive light switch to turn them off and on. . When the fuse blows I'm left with no lights other than my normal beams up front. No tail lights. Yet when the fuse IS blown I press the break and all my tail lights come on [all reds, and yellow blinker lights both constant. Yellow lights don't blink] and a glitchy light switch. NOW aside from all of that. My bottom left fog light does not work. The bulb looks un damaged. Any help greatly appreciated
The fuse protects an individual circuit. The lights which work when the fuse is blown is on another fuse circuit. They could not work if they were on the same circuit as the #8 fuse. It sounds like you may have too many lights on the #8 circuit. If the lighting load is greater than 15 amps it will blow the fuse when you turn on enough lights to exceed the 15 amps. Disconnect a few of the lights to bring the load below the 15 amp limit, and see if it resolves the fuse problem. You could increase the fuse size to 20 amps, but this is not usually advisable as the fuse is sized to protect the circuit components. If its not a result of having too much lighting on the circuit, then I would look for a bare wire which may be contacting the car chassis. The battery is grounded to the car frame, so any power source which touches the chassis will result in a dead ground, which will cause the fuse to blow. I would suggest getting a multimeter to check to see if you are getting power to the left fog light. If you are getting power, then the problem is with the bulb or light fixture. If you are not getting power, then I'd look for a blown fuse or faulty switch.
Hi i would be surprised if anything worked the Body module that other computer which works with the engine management system is confused now.
