Hatch Claw Relay Wiring Method: Threads 13, 14, 1, 5 and 6 on the base of the claw relay are 5 feet. 13 and 14 are connected to the coil, 1 and 6 are normally closed 5 and 6 are normally open
General products are printed on the circuit diagram, the terminal has a position mark, there are two claws in the coil lead-out, three contact leads.
Five feet of the five-pin relay can be named AB 1 2 3 where AB control power supply positive and negative positive and negative does not matter 1 2 3 are the control side when AB is not connected to the power supply 1 and 2 are connected when the AB After the power supply 1 and 2 separated 1 and 3 connected to the specific use of a single relatively simple if the combination of multiple relays can achieve different results hope to help you
The relay is an electrical control device. It has a control system (also known as the input circuit) and the control system (also known as the output circuit) between the interaction. Usually used in automated control circuits, it is actually a small current to control the operation of a large current "automatic switch". So in the circuit plays an automatic adjustment, security protection, conversion circuit and so on.
