Hope to provide a specific calculation process, and a series of professional knowledge, draw inferences from others, this is the best!
Selection GuideNear ideal deceleration ratio is used as much as possible:Reduction ratio = servo motor speed / gear output shaft speed
Reduction ratio = servo motor speed / gear output shaft speedTorque calculation: for the life of the reducer, torque calculation is very important, and should pay attention to the maximum acceleration torque value (TP), whether or not the maximum torque torque reducer.
The main points are two:1, select servo motor output shaft diameter can not be greater than the maximum use of the table axis diameter2, if the torque calculation speed, can meet the normal operation, but in full servo output when there is insufficient, you can drive on the motor side, do limit control, or torque protection in the mechanical axis, this is very necessary.The selection of general speed reducer includes steps of original condition, type of selection and determination of specifications.In contrast, the type selection is relatively simple, and to provide accurate conditions of the reducer, to master the design, manufacture and use of reducer, is the key to select the specifications of the universal reducer properly and rationally.
