Can I use oil for the guide rail of the machining center?
My boss wants me to add oil, I am depressed, I think it should not be good
Depends on your machine in this regard there is no requirement, if it is ordinary machine does not matter, high-speed machines may not.
A machining center, rail oil should be selected with low friction, 1 excellent, can reduce the plastic plating rail caused by the vibration and crawling; 2 high oxidation stability, can be used under high temperature, prolonging the service life of the oil; 3, high viscosity index, the machine starts low viscosity, high temperature can still maintain the proper viscosity, reduce oil leakage; 4, and cutting fluid such as the separation performance of the emulsion has been strengthened, prevent the emulsion away; 5, to prevent the workpiece turns; wear 6, excellent performance.Two, car oil can replace rail oil, but not when the car rail oil oil, automobile oil has several important lubricating oil additive is not common, heat, oxidation, cleaning, dispersion, mobility, and motor oil is a multi-level, such as 10W-40, can be ensured to provide lubrication performance at 25 degrees below zero. The machine tool lubricating oil is usually single stage, such as No. 40, No. 68, if added to the ordinary oil vehicle, tens of kilometers will let the engine scrap.Three, lubricating oil is actually a highly targeted service industry, for different equipment in different environments corresponding to different oil lubrication to guide oil, hot days of the south in general not the same as their high molecular viscosity.Four, recommended: special guide 68# oil processing center, North general 32# or 46# please refer to the specific machine instructions, but absolutely can not use the hydraulic oil, do not lose the greater.
