Home > categories > Mechanical Parts & Fabrication Services > Moulds > Can you tell me how the injection molding machine has a large closing line and the batch front?
Question:

Can you tell me how the injection molding machine has a large closing line and the batch front?

Can you tell me how the injection molding machine has a large closing line and the batch front?

Answer:

If the mould quality is ok, it can be adjusted. Try the following: Reduce injection or pressure pressure properly. 2, appropriate reduction of temperature setting. Increase lock mode high pressure properly. 4, reduce the injection rate appropriately. Reduce mold temperature appropriately. I wish you good luck with only one change at a time.
Moulding line big flash, must first rule out the mould with no problem, with red lead powder with the mold can be ruled out, if the parting surface not fully fit after clamping to have crack, can produce big flash. It is not a problem to exclude the mold, the process consideration: 1, the material flow is too good, the cylinder temperature is properly lowered
Like the first floor of the adjustable or no problem but you should pay attention to mold exhaust good with the bad, there are many reasons a inside,,, that is, experience, hope you more like the best I am a maintenance of injection molding machine, hydraulic or servo principle is the same

Share to: