Hello I remember carbide knives have several classifications As if it were not the same as it is now, can you tell me the same and different models as before? What material can they make?
I remember Zhuzhou Hua tungsten. They have a full range of them. You can go to their Baidu company
The difference between cemented carbides A320 and A325 is that A320 is smaller than A325. A320 length is 20 A325, length is 25 QQ, 404200629 to split bar carbide saw blade, including alloy cutter type, matrix
YT15 (P10) = 91 for hardness of carbon steel and alloy steel continuous cutting and semi refined car finishing. Intermittent cutting when finishing. The cyclone car wire, the semi finish and finish milling, rough and fine hole expansion. YT14 (P20) = 90.5 hardness suitable for carbon steel and alloy steel uneven surface roughing the whole continuous cutting, interrupted cutting is the semi refined car and finishing, the rough milling, casting hole reaming etc.. YT5 (P30) = 89.5 for hardness of carbon steel and alloy steel [including forging. Rough parts for stamping and casting. Rough planing, half fine planing, rough milling and so on. YG8 (K30) = 89 for hardness cast iron, nonferrous metals and alloys, rough turning, non-metallic materials, uneven surface and intermittent cutting the rough planing, rough milling, drilling hole and deep hole reaming. YW1 (M10) = 91.5 for heat resistant steel material hardness, strength of steel, stainless steel and alloy steel and other hard steel processing, is also suitable for ordinary steel, machining of cast iron.YS25 (P25) = 90.5 for hardness of carbon steel, cast steel, high manganese steel, coarse high strength steel and alloy steel, milling and planing. YG6X (K10) = 91 for hardness of alloy cast iron. Finishing and semi finishing machining of cast iron. YS8 (M05) 92.5S for hardness is more than or equal to the iron-based, nickel based superalloy, high precision machining of high strength steel, finish machining of chilled cast iron and heat-resistant stainless steel, high manganese steel, hardened steel. YG8N (K20K30) = 90 for hardness rough machining of cast iron and non-ferrous metals, is also suitable for the finishing of the rough machining of stainless steel. YT30, YS30, YG6A, YG3, YG3X, YW2, YD777, and various non-standard products.
