Submersible pump capacity I was 1500W, the normal use of voltage is 220 kV line 600 meters with 6 square aluminum after the start of the effluent is small, and the voltage of submersible pump is reduced to 150 volts could not use voltage of 380 volts (two).
Small amount of water, it should be the lift can not meet the requirements, change the submersible pump is the best solution. With 380 volts, it is very likely to burn out the pump motor.
This is the reason why the line is too long and the power consumption is too large
Absolutely not, because 220V is not the same as the 380V waveform. Submersible pump single-phase motor is generally single-phase capacitor motor. The working principle is different from that of the single-phase 380 motor. If the power capacity is enough, it is recommended that you increase the wire (you can buy a line and go to use, to avoid waste), preferably with copper wire.
