GSK980TA CNC lathe tool holder how to move
Hand hold tool motor, and then press the knife, I feel that there is no motor movements. 1, if the turret motor does not act, it should be a circuit problem, please check whether or not the work of the holder of the relay, the power supply is not normal, etc.. 2, if there has been support motor action and feeling in the action, that should be a tool of mechanical failure, please rest on the lower left one screw off with six angle wrench tool to see whether the worm shaft can rotate the turret rotation if it will rest to 45 degrees and then try to change the knife, if not to move it please remove the knife. 3, if the knife motor action and click No action, it may be broken or the knife knife signal line transmitting disk bad.Numerical control lathe: in the numerical control machine tool processing part, mainly depends on the processing procedure, it is different with the ordinary machine tool, does not need to make, the replacement many molds, the jig, does not need to adjust the machine frequently. Therefore, the NC machine is suitable for the processing of parts of frequent replacement of the occasion, which is suitable for single and small batch product development and production, and new products, so as to shorten the preparation cycle, save a lot of equipment costs.
Hand hold tool motor, and then press the knife, I feel that there is no motor movements. 1, if the turret motor does not act, it should be a circuit problem, please check whether or not the work of the holder of the relay, the power supply is not normal, etc.. 2, if there has been support motor action and feeling in the action, that should be a tool of mechanical failure, please rest on the lower left one screw off with six angle wrench tool to see whether the worm shaft can rotate the turret rotation if it will rest to 45 degrees and then try to change the knife, if not to move it please remove the knife. 3, if the knife motor action and click No action, it may be broken or the knife knife signal line transmitting disk bad.
Behind three with the line for a try, if the impact of the knife should be a pin problem, open the adjustment OK
Tool holder for the following reasons: first check whether the system has a positive output.Second check whether the power supply is normal.Third may be a mechanical card dead.
