How can the old camcorder Sony camera upload videos?
The material captured by the cassette camera can not be uploaded directly on the tape. Complete the upload need the following steps: . a video capture card acquisition card requires a simulated composite or digital 1394 interface, depending on what the camera output . the card installed to the computer, including hardware installation, software drivers Install two steps. . adjust the camera to the playback state so that the camera can play back the contents of the tape . through the audio and video cable to connect the camera and the capture card to the tape on the signal transmission to the computer . collected in the editing software to collect through these Steps to complete the video and audio upload.
The problem is very simple, the above two basic are explained clearly, I am not much here to say. It is important to note that non-professional personnel entering the elevator shaft construction must obtain the consent and coordination of the elevator maintenance personnel. Otherwise unauthorized access to the elevator shaft construction is not in line with the relevant state laws and regulations, but also very dangerous.
To use the elevator dedicated video cable, tie the elevator cable, the car on the drilling string and install the camera ridge 埂 笭 locust locusta ho ho raft, you can also use the wireless device, [[can not use the network cable]
Use a flattened elevator to tie the elevator to the flat. Do not tie too tight, as long as you do not go to both sides just fine, and then from the bottom of the more than the ridge hoarding locusts on the hoop board raft, from the top of the set aside the thread into the thread, just fine. I suggest you and the elevator to discuss the power cord will not cloth, and directly from the elevator to take electricity.
