How do I remove the full automatic washing machine reducer?
(4) put forward the dumping of the washing machine, placed face down, you can see the bottom of the structure of the washing machine with the sleeve or a small wrench, unscrew the fastening screws on the mounting bracket and remove the retaining frame, then remove the triangle belt, and a sleeve or a small wrench to unscrew the fastening screw in the fastening plate reduction speed clutch so that you can remove the gear clutch.(attached: if the bucket is rusty and cannot be removed, the clutch is broken and no longer needed, the action sequence is as follows: take fourth steps first. Fixed screw removal washing machine clutch and below the belt, and then do the third step, washing and dewatering shaft nut after directly with a hammer and iron shaft alignment clutch, to knock him down, to two people, one person to carry on the dehydration barrel, a person can put a drop hammer. Panasonic to clutch. Install from bottom to top when installing. The sealing surface is clean and generally does not leakThe order of the change and deceleration clutch is opposite to the order of removing the reducing clutch. That is the first with fastening screws on the supporting plate gear clutch changed, then loaded on a triangle belt and a fixed frame, the washing machine erected, the dewatering shaft installed in the clutch gear gasket, put the washing dewatering bucket and a cushion, fastening the dewatering shaft nut, square core installed gasket, wave wheel, and then use the screw impeller the fastening wheel, finally put the bucket ring and the fixed seat can be controlled.
(1) unscrew the fastening screws of the control seat with a screwdriver and remove the control seat. At this point, it should be careful not to pull the pressure pipe behind the washing machine connected with the water level switch;(2) unscrew the fastening screw on the fixing ring of the bucket with a screwdriver, and remove the fixed ring of the bucket;(3) with a screwdriver under the screw impeller, impeller and come up with the core, the gasket can see when washing, dehydration shaft nut fixed seat and above the washing dewatering bucket below, and then use the wrench or a special tool to the dewatering shaft nut, and then come up with a deceleration clutch dehydration shaft on the pad off the bucket down, washed, and then come up with a gasket on the dewatering shaft of (this one is very important, for the new clutch also put it back!!) ;
Automatic washing machine clutch replacement operation procedures:Tools: a large cap sleeve (38mm can find the car tire industry, borrow) a set of socket spanner will mainly use 10mm; 14mm is also a 13mm wrench, 4 metal tube about 600~800mm a pipe; a hammer; a (better).If the deceleration clutch is broken, it is necessary to replace the new clutch. First, we need to remove the bad clutch, as follows:
2. Screw out the impeller screw, take out the impeller, then screw out the big nut of the fixed inner barrel with the special sleeve (Q818, Q828 model, the inner barrel is fixed with four M6 bolts) and take out the inner barrel;3, on the ground, first put a soft cloth, the washing machine side upside down, with a sleeve spin out two fixed clutch on the protection of the bolt, take off the protection frame;4. Unscrew the four bolts of the clutch with a sleeve, take the belt, and finally take out the clutch and replace it with the new clutch;5 assemble the original steps.
