How many kinds of materials are there in ceramics?
Domestic ceramic fiber felt from the content of AIO were% and%, the former use temperature of 110 to 000 degrees, the latter is l000 DEG C by the ceramic fiber felt with adhesive is divided into hard ceramic fiber felt (aluminum phosphate adhesive), ceramic fiber felt soft (adhesive latex, polymeric aluminum and water glass methyl cellulose, latex, 11 aluminum phosphate composite adhesive) and ceramic fiber wet felt (adhesive silica sol) three.
Ceramic fiber, referred to as "ceramic fiber felt", is a kind of high temperature resistant refractory material (such as precious stones) by arc melting, compressed air sprayed with a fibrous material, also known as "ceramic fiber cotton.". Using ceramic fiber cotton, it can be made into all kinds of ceramic fiber products.
According to the performance of the heating furnace and the ceramic fiber felt the temperature of the furnace wall heat surface layer can be made of hard ceramic fiber felt products size 00 x 00 x 0 (10) follows the basic properties of MM ceramic fiber blanket: (L) the use of high temperature to l000 degrees. (Tao Xianzhan) the density is below 00Kgm (usually 10kgm), only light, heat resistant lining L - 1. () the heat capacity is only 1 of the light heat resisting lining and the light fireclay brick. (ceramic fiber) at high temperature, volume stability, residual shrinkage is very small, without leaving contraction or expansion joints, construction convenience. () small thermal conductivity. On the hot surface temperature of 00 degrees Celsius (average temperature) guide coefficient of 0.0W (M. K); 00 (the average temperature is 1 DEG C) to O.0W (m.k); 1100 C (average temperature c) to 0.1W (m.k), about lightweight clay brick, 1 light at the 110 heat resistant lining. () sound insulation effect is good. The ceramic fiber coating can reduce the high-frequency noise of frequency less than 1000Hz, and can also absorb some low-frequency noise (()) with a certain tensile strength. () good chemical stability. () elasticity is good (at room temperature, elasticity%), easy to transport and install. (10) it has better resistance to airflow erosion, and can withstand 0 - 0ms airflow erosion.
