Home > categories > Machinery & Equipment > Stepper Motor > How to control the displacement and speed of the stepping motor?
Question:

How to control the displacement and speed of the stepping motor?

How to control the displacement and speed of the stepping motor?

Answer:

The driving signal of the stepping motor must be a pulse signal. The speed of rotation is proportional to the frequency of the pulse!!!This stepper motor has an angle of 5.625 degrees. A circle of 360 degrees requires 64 pulses to complete!!!
3, stepper motor with instant start and rapid stop superior characteristics.4, change the order of pulses, you can easily change the direction of rotation.Give you a program, refer to the reference
2, the 28BYJ48 5V driver is KINGBOX supporting the 4 phase 5 wire stepper motor, and deceleration stepper motor.The speed reduction ratio is 1:64, and the stepping angle is 5.625/64 degrees. If you need to turn 1 circles, then you need360/5.625*64=4096 pulse signals.
Main characteristics of stepper motor:1, stepper motor must be driven to operate, the drive signal must be a pulse signal, when there is no pulse,Stepper motors are stationary, and if they are properly pulsed, they will rotate at a certain angle (called step angle). turnThe speed of motion is proportional to the frequency of the pulse.

Share to: