Without the bubbles: 1, to select the good quality of film, good film has wear resistance and high transparency, the rubber-faced is even without the bubbles. 2, The cell phone screen is cleaned up with clean cotton cloth which does not epilate, do not stay the dead angle. 3, when sticking the film, the phone is fixed, and then uncover the protective film of the film, but not uncover the all of the film, only a third of it. The uncovered film is aligned at the top of the mobile phone screen in the left and right, and gently put up and adjust the position. After the film is pasted, you should use the towel cloth or cell specific towel to slowly wipe from the top to the bottom in order to make it fully bind. And then, you gently uncover the 1/2 film pellicle, the next operation is same to the above until the entire process is completed.
Sticking the film without the bubbles 1, Firstly, you should clean up the dust and oil stain on the your hand by the hand sanitizer. 2, Use the glasses cloth or the soft cloth with no hair?slip dip in a small amount of water to wipe the surface of the phone, and the clean up the dust and fingerprints on the surface. 3, tear the one side of protective film, and then alige at the top and sides of mobile phone and paste the film. 4, When you paste the film, you should maintain constant speed, please pull back the film if there is bubble, in order that there is no bubble on the surface of film. Then use the wool or cushion scraper to avoid scratching. The film will be slowly pressed on the surface of the mobile phone, even if there are the bubbles, they will be less. 5, After finish the pasting, you should treat the regional bubbles. Use the hard card and credit card which are wrapped by the screen soft to slowly scrap the bubbles out of the edge.
The main reason of bubble is the dust. Before sticking the film, you can use the adhesive?sticker to stick for several times in order to stick out the dust. When you paste it, you do not fully tear it off , but tear a section of distance, and begin to paste. Bank card or ID card. Take out your film. After you determine the direction, and then align at the corners and edges on the screen. Use a piece of tape to stick the side of the phone and a side of the film, carefully tear up the old film. After the screen is cleaned up, tear the first layer of the film and directly paste it on. Because it has been fixed on with scotch tape in advance, it will not deviate. At last, wrap a side of bank card or ID card with the glasses cloth and squeeze out the bubbles and tear up the second layer
If you don't want to have the bubbles: 1, to select the good quality of film, good film has wear resistance and high transparency, the rubber-faced is even without the bubbles. 2, The cell phone screen is cleaned up with clean cotton cloth which does not epilate, do not stay the dead angle. 3, when sticking the film, the phone is fixed, and then uncover the protective film of the film, but not uncover the all of the film, only a third of it. The uncovered film is aligned at the top of the mobile phone screen in the left and right, and gently put up and adjust the position. After the film is pasted, you should use the towel cloth or cell specific towel to slowly wipe from the top to the bottom in order to make it fully bind. And then, you gently uncover the 1/2 film pellicle, the next operation is same to the above until the entire process is completed.
