How will the pulley of the washing machine be removed
The washing machine turns upside down, first the belt is removed and the fixed screw in the middle of the pulley is removed. If you have the best, you can take the pulley down. There is no rama, and you can use a hammer to gently tap the pulley, not just one point, but a symmetrical one. If still not knock down, tied with wire or rope pulley, lift force, reoccupy hammer inner shaft, pay attention to the shaft between the hammer to pad some copper, aluminum or wood, in order to avoid the shaft type coarse. Fixing the belt wheel shaft will not follow the rotation, of course, the square hole of the pulley will be set on the shaft, otherwise the pulley will follow if the pulley does not rotate.
Use a steel bar to stick to the belt and wheel, then turn the wheel and come down. When you put it in, it goes up.
The washing machine is not unopened for a long time, the pulley and the shaft rust, not easily removed. Clever way is to put the fixed pulley set screws, dolly tub inside into the water, into the table (a bit more), start the washing machine in the table washing, pulley will drop down, very ShengJin. That you try the following way: 1. The filling of lubricating oil removal method using years of washing machine, the raised edge will be worn on the pulsator, appear different degree of crack and damage in the process of washing clothes or buttons, etc., so you need to replace the pulsator in time. But many users do not have the bearing oil when the washing machine fails. So there is no fixed screw on the wheel before the wheel is damaged. In addition, the detergent that is used contains a lot of alkaline material, make the screw rust in the shaft, can not twist easily. First, lubricate the screw with a bit of oil or osmotic oil. After a while the oil penetrates the screws and shafts, and then screws.
The screw is rusty and you have to put on the kerosene for half an hour and knock again, no more. There is no way to unload it. If the screws are to be screwed, take your time. When you apply kerosene, you should gently beat the kerosene and soak it in. Unless you break the hole and re-use the thread, you can.
Trying to hold the first belt pulley and then using a wrench, discharging screw you strength is enough big words don't have to do is live pulley with the hand, can also use a bit bigger and longer screwdriver don't live it, don't pulley, clockwise discharge screw counterclockwise.
