Ready to install wall hanging furnace, but the northern water quality is hard, on-line check, you can contain water through the crystal water to soften the water, but I do not know if this is really useful for wall hanging furnace? I wonder if I have done this. What's the effect? Who will explain, please? Thank you
Hello, can not tell you how much effect can reach, but the use of phosphate crystal silicon softener to soften water, boiler operation, the use of the boiler is good, mainly to reduce part of the scale. If the wall heating furnace water is used in general life water, it is recommended to use three to five years to clean, otherwise it will shorten the service life of wall hanging furnace and increase the rate of maintenance!! I hope I can help you
3, boiler fouling mainly from the hot water heat exchanger system, because you take a shower of water from the tap water, the higher the temperature scaling probability is bigger, so according to the use of water hardness you and your hot water rate to choose according to the water softening device. (generally speaking, in your home, a hot kettle with boiling water, if 1 months or so will cause obvious scale, it is recommended to install the softened water device.)
1, the installation of soft water change devices must be better than not installed.2, the operation of wall hanging boilers are mainly heating and sanitary hot water two systems, in general, heating system is closed system, if the system does not drain water, a heating season does not need water.
