When the water softener backwash, the salt pipe is also water, is the valve head problem, or installation reasons?Only change the valve head, valve head is the new type, forget ~
At present, the mainstream of the soft water treatment technology in the market are fixed bed cation resin exchange process, the main components are: control valve, resin tank (another metal pressure vessel), cation exchange resin, salt boxThe common trouble of fixed bed water softener is:1, water softener without regeneration; 2, equipment does not absorb salt; 3, water quality substandard; 4, cycle water less; 5, drainage non-stop; 6, salt water injection non-stop; 7, resin running leakage
Control valve failure, mechanical and electrical contact and mechanical failure, electronic interference?,Can the flow type flow signal be transmitted normally?Whether the running conditions are satisfied or not, some users will let the water softener run intermittently. There is a phenomenon of water and electricity not synchronous, and the equipment will be regeneratedEither no electricity or water, the regeneration process is worthy of the name, no substantive role. 2, does not absorb saltSalt suction multi valve now is the use of the Venturi effect produced by the Venturi tube siphon suction salt, as long as we understand the Venturi effect also understand the cause of salt absorption. The cause of the Venturi effect, also known as the venturi effect. This phenomenon by its discoverer, the Italy physicist Venturi (GiovanniBattistaVenturi) name. This effect is referred to in the vicinity of high gas flow will produce low pressure, resulting in adsorption. This effect can be produced by venturi. Interested can go to study here, not to elaborate. Do not produce salt absorption phenomenon and the following reasons in a water softener.
Below on the specific failure to do specific analysis and provide solutions, 1, water softener can not be recycledAt present, the water softener adopts multi way valve control, and its control modes are mainly manual and automatic two, automatic and dividedThe type and flow control. No regeneration phenomenon is more common in the automatic control system, a common phenomenon is the system parameter setting error. Now the automatic control valve is mainly used in electromechanical and electronic control, electromechanical control valve is mainly fleek and imitation fleek, in addition to AUTOTROL. At present, the market has not seen, but its control principle is the same. When debugging to set a good regeneration interval, water production cycle time, the type steel sheet drawing wheel to set the date regeneration interval, flow by setting the disk flow cycle of water to control the regeneration start, the user is more the two lead to the regeneration is not set. Electronic control failure cannot be regenerated is relatively complex, the control mode is controlled by the chip technology, users need a simple programming operation, it is setting control parameters, The setting is the use of code setting, such as control valves AUTOTROL, fleek, new is this way, if the code setting error will cause the water softener to regeneration, can refer to the corresponding parameter setting instructions set.
