Is there any way to keep the ice from sticking to the mold and remove it from the mold
It is easy to separate the ice from the mold by simply rushing under the flowing water (tap water).
In the hot water under the mould, soon the edge of the ice melts and buckles.After freezing, soak the die in the water and pull.
The general mold is made of plastic, catching both ends and turning in the opposite direction
The best way is normal with mold, ice, frozen after good, put the mold in bowl with cold water for a while is ok, it is not necessary to use warm water, don't have to put the water into ice. And then you take it, and then you have a twist on both ends of the mold.
