Led how to install the light belt?
Do not use the power supply during the installation or assembly of the lamp belt. Only the connection, installation and the correct condition can be used to connect the power supply,5. installation of LED lamp belt under cold and hot air can be electrified for a few minutes, so that the lamp body becomes soft, easy to bend, and then power off installation.
Each interface must be solid and free of potential defects. When outdoor installation, the interface must be sealed with glass glue or other appropriate methods to ensure that the interface is flooded.
Please do not use heavy objects to knock on the lamp and to shock when installing and using it.At the end of 7. tube must be caught before the tail plug with glue.8. only the same specifications, the same voltage of the two section of the lamp string can be connected to each other, the total length of the series shall not exceed the maximum allowable length
Please don't light the band when the 1.LED light is in a roll.2., only on the lamp belt with a scissors mark on the body to cut, otherwise it will cause a unit is not bright.3. installation, please bring light bent to one side, exposing the 2-3MM copper wire, and wire cutters cut clean, there shall be no burr, avoid short-circuit.
