Led to shoot the light is broken how to change
Light bulb and the reflector lamp cup is an organic whole, first pull the lamp cup on the back of the power supply (ceramic system, circular!) To remove the O type spring clamp, pour lamp cup!!!!!! Check mark on the lamp cup, the wattage and voltage requirements, shoot the light points, high voltage (220 v) and low pressure (below 36 v) two! Don't mistake!!!!! Not sure if he took the old lamp cup reference to purchase! A few bucks!
Nails dig is commonly used in the edge of the lamp tube (position) linking to the smallpox condole top, a little bit hard pull became one! Two used to locate the wire spring clip!
Now turn off the lights switch (for safety) had better be to turn off the total power supply, and then into the drive power line (also can be directly cut short), then remove the bad driver And then put the new drive power input skin, two light thread dial the skin. Let one of the root drive power cord wrapped around the lamp power cord (chaozhou both positive and negative), on the one of tie up good, good electrical tape, another root connection same good tangle on electrical tape.
