...little grinding bits come in.The seal can be O.D. or I.D. and needs to slip on and off fairly easy, just like the seals in the tubes that contain the littler grinding bits Dremel makes.
The seal can be O.D. or I.D. and needs to slip on and off fairly easy, just like the seals in the tubes that contain the littler grinding bits Dremel makes.
1 piece of heat-shrink tubing to insulate your solder connection between EL wire and stereo wire (RadioShack) 1/2 6x32 clear polycarbonate screw to hold end bushing in (this is a recent addition, because the end bushings have come out of some of my blades when they are dueled with. However, these are rather expensive, as screws go. I think I payed about $10 for 50 screws.) hot glue, or silicone for end of blade super glue to glue in top and bottom bushings Note: I don't really like RadioShack all that much. I have a much better electronics store locally that I use that has a better selection and cheaper prices, but you can't order from them online, so I know you should be able to find what you need at RadioShack) That's just for the blade.
