Numerical control lathe tool holder does not match the system cutter number
The system shows 3 knife, and the knife is actually the number 2, how to turn is not in place?The angle of the Holzer component of the turret is rotated to a position. For Holzer components: the 4 station of the disc has 4 elements on the circumference of the elements of the Holzer, the circumference of the 6 stations on the circumference of the disk has 6 elements (or the adjustment of the elements of the wire in the cabinet of the wiring in the position of the cabinet) (in the case of the elements of the unit).
Is not the cover of the knife on the wrong side of the knife on the lid off
The turret operation is not in place (sometimes appear suddenly, the mid position stay) is mainly due to signaling disc contact and elastic sheet contact displacement, namely the cutter disc position signal to a fixed offset bakelite. At this point, it should be adjusted to the contact position of the contact plate and the elastic plate. If you still can not rule out the fault, it is possible to send the disk clamping nut loose, resulting in the location of mobile.
