Home > categories > Security & Protection > Road Stud > Potty tained in daytime But bedwetting?
Question:

Potty tained in daytime But bedwetting?

My daughter is 2 and a half years old. She is day time potty trained. I put a pull up on her at night because she dosnt know to go pee. It seems every night that she completly wets her bed. She also drinks 1 to 2 cups of milk at night. I know i shouldnt let her but she cries otherwise.

Answer:

Near the ceiling, where the gas will rise to. Ours is about two feet down from the top of the wall.
Proper placement of a carbon monoxide detector is important. If you are installing only one carbon monoxide detector, the Consumer Product Safety Commission (CPSC) recommends it be located near the sleeping area, where it can wake you if you are asleep. Additional detectors on every level and in every bedroom of a home provides extra protection. Homeowners should remember not to install carbon monoxide detectors directly above or beside fuel-burning appliances, as appliances may emit a small amount of carbon monoxide upon start-up. A detector should not be placed within fifteen feet of heating or cooking appliances or in or near very humid areas such as bathrooms. When considering where to place a carbon monoxide detector, keep in mind that although carbon monoxide is roughly the same weight as air (carbon monoxide's specific gravity is 0.9657, as stated by the EPA; the National Resource Council lists the specific gravity of air as one), it may be contained in warm air coming from combustion appliances such as home heating equipment. If this is the case, carbon monoxide will rise with the warmer air. For this reason, I suggest mounting the detector on the ceiling. This also puts the detector out of the way of potential interference, such as pets or curious children. If you need further assistance, please visit: electricalblog.gilchrist-electric
Your good co detectors usually plug into receptacles.How many people have receptacles in there ceiling? Nighthawk with digital read out is probably the best, which plug into a receptacle.
close to ceiling as carbon monoxide is lighter than air
I have a trick to use with most hazardous materials. Hcl is a bad acid NACL caustic acid If u mix the two until u have a ph of 7 ,now what u have ?? Now u have table salt and water. Most hazardous chemicals can be disposed of in this way . I did work in the oil field and they use HCL very strong and if we had a spill we use caustic soda to neutralize it. Even if it gets into the ground water most bsaic has a basic component.

Share to: