I'm wiring up a kenwood sub and amp. Everything is connected except for a quot;power control wirequot;. Not sure what this does or where I should connect it to. Any help?
run a wire from your amp ( there should be a place for it by the ground wire and power wire called REM for remote ) to the back of you radio. look on you harness and there should be a blue wire to connect it to. that is if it is aftetmarket. if its factory radio then i cant tell you how to do it on here cause that would take to long.. haha..
can you connect more than one device to the center unit power control wire?
For the best answers, search on this site https://shorturl.im/awoXJ IF your car had a power antenna, then you should be OK. IF it does NOT then I would question where the wire is going before adding another wire. The problem is that the remote turn on or power antenna turn on lead coming out of the head unit cannot handle much current draw. Hooking too many things to it without using a relay can burn out the circuit inside of the head unit.
power control wire from were the amp or the stereo if its from the amp then it might be eighter the remote or the power but you said that its all wired up all ready so im thinking it might be the remote if so you run a wire from (power control wire) to the blue wire coming out of your stereo im not sure if we are talking about the same thing here but be more specific so our answers can be more accurate good luck
