Pvc buckle board, installed smallpox, the specific steps, must be detailed, to DIY Kazakhstan
First of all, the amount of room width, and then cut off, only a little bit to, truncated the board useless! The And then the board of the work of sewing inside, the mother sewn on the outside, the mother sewn on the deputy dragon to play a self-tapping screws. On the first piece, and then the back are the same. The last piece of the first amount of the amount of the remaining width and then cut the board a little bit, do not cut off. Install the last piece on the line.
Hello, the following began to hang pvc buckle board ceiling. Material; pvc buckle plate, pvc trim corner, card main dragon, deputy dragon Tools; impact drill, glass gun, glass glue (porcelain white) self-tapping screws, screwdriver, 6 PCT top burst, 8% impact drill, 6% screw, 6% nut, Start construction; first set a point in the porcelain wall, see the ceiling hanging high, and then hit the water, in the pvc trim corner sticking glass glue, and then stick in the flat water line, the angle and the outer corner is more trouble. And then side by side in the zeal hit 4 holes, (8% impact drill) installed 6% burst, remember to open the top. And then from the top of the ceiling to pvc trim angle, the height is 6% screw to cut the length of the cut in the 4 4 4 screw at one end of the twist nut, and now began to card on the main dragon, and then the deputy dragon Hanging out, so that the ceiling board ceiling out of the shelf.
