(a) State boiling point of pure water.?(b) describe a chemical test for water and its results?
I do not know motorcycles but in a car it would seem that there is some leak in the system allowing air to get in , or you need a brake master cylinder, the unit that pressurizes the fluid.
Blleding brakes on a bike can be a pain in the ss and often needs to be done several times. Be sure to run a small hose from the bleeder into a container of fluid , not only to keep air out but also to save your fluid to refill the MC as you bleed You just haven't got them bled thoroughly
there's a great variety of feasible issues that should reason you to leak brake fluid a number of them is a leaking caliper or brake line. often whilst a caliper leaks(and often a line) u dont could replaced the pads because of the fact fluid have been given on them yet I frequently sparkling them off with some brake purifier and notice if there ok from there; sometimes they're to saturated to save. the acceptable way you could tell whether it fairly is a caliper or line is to look in case you spot fluid strains on between the wheels of take a glance in the back of them to work out the line and the interior the wheel. there is likewise another feasible issues that should reason the pedal to sense spongy or low to the floor, including a bad grasp cyclender or air in the device, or undesirable brake booster. maximum of brake fluid leaks from older vehicals come from calipers or line, on an identical time as a bad grasp cyclender might reason a low or spongy pedal.
a)At 1.0 Bar, the boiling point of pure water is 100 deg C or 212 Deg F. (bp varies with different pressures) b) Add anhydrous copper (II) sulphate crystals (white in colour) and it would turn blue in the presence of water
