ok so my rims are pitting and the clear coat is pealing offso i want to refinish them and clear coat them afterso i would sand them with 800 then 1000 then 1500 then buff them with polish then clear coat them? or sand them, then clear coat it then 1500grit sand the clear coat then buff with polish?Thank you :)
I would tackle this one of two ways: 1Go to Lion Yarns or one of the other sitesSearch for a blanket I like in a similar yarn weight, follow directions2Knit a gauge swatchMultiply stitched per inch x number of inches I want my blanket to be(Note: An LL Bean full size quilt measures 85 x 95) Let's say I'm using Vanna's Choice (I don't like acrylic generally but it makes for a washable blanket) on 9 needles and it works out to 4 stitches to the inch4 stitches times 85 inches 340 stitches to cast onThat's a lot of knittingYou'll definitely want to use a circular needle to give yourself extra space for the stitches or knit in sectionsYou may also want to refer to other posts regarding knit vcrochet crochet is a lot faster AND eats yarnTrade off! Happy Knitting!
I have started knitting with Double Knit wool with 232 stitchesWhat would the width approx be after completed.? Planning on 9 rows K1Then 29 st Seed stitch, then 29 st Rib (K1 P1) .so it alternate in next block to make the patternEnd of with 9 rows K1 to finish off Thanks
I think you want to stay away from aluminum with any sand paper and go buy some aluminum polish and a buffer pad and spend some time polishing the aluminum getting off the clear coat is a challenge, once that part is done you get to polish and polish and polish and polish and polish,
