Shower how to install ah, mainly asked how to set up hot and cold water pipe joints ah
First buy hot and cold faucet, the amount of about the width, set a good place, hydropower union to help you do a good job
Shower room base should be filled, the base is installed without water, shower room and wall joints should be no leakage phenomenon.
After installation to do the water test, save 2/3 water, no leakage after 2H; and irrigation in the overflow test, check for leaks. After passing the test must be sealed with a good film, covered with more than nine percent sheet metal cover to prevent hard objects fall caused by surface damage. Check the acceptance before the repair hole may not be closed.
1. The first step should be for the installation of the basin. For the installation of the basin, it is important that the water in the bottom basin is very important. If you keep the water, then the installation will have a great impact. At the same time the bottom basin and pipe connection, pay attention to solid, to prevent water leakage. Hose, you can adjust the distance as needed.
2. Use water to check to ensure the accuracy of the installation, and to ensure that the water can flow normally. And then followed by the drilling operation, used to fix the wall of the aluminum material.
3. Then into the fixed particles and other ingredients, and then the aluminum bar is fixed above the wall, and then will be used to fix the glass material in the bottom basin drilling place.
4. Drill a hole in the fixed glass, then install the mount, and then connect the jacking. Then it is for the installation of the shelves. We know that the shower room if you do not put the shelf, then go into the bath when the replacement of clothing is not good to put.
5. Install the activities of the door, you can save space, and push and pull will be more convenient. Then do good waterproof work between the glass. With glass glue to seal the need to seal the place is also sealed.
6. Then for the installation of the shower room to check, to ensure that the installation of the shower room waterproof normal, smooth drainage, can be used normally. If there is a certain lack of water and drainage, pay attention to the renovation, while the screw and the like to tighten out. And then remember to wipe the shower room with a rag.
