My solar water heater electric heating in the bucket at both ends of the electric heating hole is 4 points, silicone sealing ring broken, bought a new, but difficult to install? I would like to ask the master coup?
Vacuum tube1 socket installation. Install vacuum tube collector, the lower part of the installation, and the installation seat bracket at the specified location.2 intubation. First check the insulation layer of the water tank liner sealed silicone rubber ring, and then check whether the vacuum tube tail angle is broken, and then check the transparency of the film, such as mercury, check whether there is a burr processing, roundness. The vacuum tube outside the sealing rubber ring fled into the vacuum tube about 15cm, with soapy water to fully wet the nozzle, the right hand to hold the vacuum tube tail, first, in order to protect the tail angle of the process, two is easy to insert the force. The vertical direction of nozzle inserted into the vacuum tube, evenly into the light rotary water tank, after inserting the back seat, so all tubes installed.
3 after the installation of water tanks and vacuum tubes, and then check all the screws, and then tighten.Fixed supportGenerally use cement pier, expansion bolt or wire rope fixed bracket, of course, need to have their own roof to choose the best way to fix the situation. Methods: the fixed wire rope wire rope or a large set of steel frame and barrel on the front bracket of the left and right holding about u ring, and tighten the nut, the four steel wire rope or steel to the water heater four angle direction, select the appropriate location in the parapet or other places, according to the drilling expansion hook, steel wire a rope or reinforced with the corresponding expansion hook type U ring is firmly connected.
Mounting bracket1 installation location selection. General choice in the roof, the direction is to sit north to south, is heading west to 5~10 degrees, to ensure there is no shelter. Home pipelines should also be reduced, which can increase the duration of sunshine.2 assembly bracket. The installation should be in accordance with the instructions of the front and rear pieces together, and then use a wrench to tighten the screws, no loose. Then the installation piece before and after the side support, reinforce to the structure of the.
Dead work1 prepare construction tools. For example: screwdriver, wrench, drill, etc..2 open the water heater packaging, according to the packing list to check whether the accessories are complete. 1) the number of vacuum tubes are complete and perfect; 2) electric heating is intact; 3) whether the water tank body dent; 4) supporting the auxiliary parts are complete; 5) can only control the packaging is intact, and so on.
