The basics of driving a forklift
Note the position of the gearshift and the reverse pole. The speed of the forklift truck is slow, usually only one and two blocks, and a reverse gear is specially set up. When driving, first hang in the reverse gear, switch the forklift to move forward or back, then push the shift lever to 1 stop and start smoothly. The forklift does not stop changing direction, causing damage to the transmission.
Note the position of the gearshift and the reverse pole. The speed of the forklift truck is slow, usually only one and two blocks, and a reverse gear is specially set up. When driving, first hang in the reverse gear, switch the forklift to move forward or back, then push the shift lever to 1 stop and start smoothly. The forklift does not stop changing direction, causing damage to the transmission.
Correct steering wheel. Forklift truck operation site is small, small turning radius, steering sensitivity, therefore, more modern forklift truck adopts hydraulic steering method, and on the steering wheel to install a 360 degree rotation of the ball back and forth or the handle. When driving, the handle should be held in the left hand. Many beginners are not used to this way of driving, steering wheel, when time killed some also like the direction of a place, it will cause steering mechanism of wear and tear.
Adjust the distance of the cargo fork according to the volume and shape of the goods, and make the right and left fork force even. When taking the cargo or pallet, the fork should be inserted at the insertion hole level of the pallet, avoiding the collision as much as possible, and then the fork of the cargo after the cross, and then the door frame. Before you start, look around the forklift and the cargo stacking and keep the fork from 20 to 30 centimetres above the ground to prevent the cargo from falling. The whistle should be sounded when entering or turning.
When uninstalling, it is strictly forbidden to unload the plates, turn the pan or use "archery" to avoid damaging the fork. The strict execution of the "five non-fork" in the job: the center of load of the center of mass of the cargo over the fork. A single fork is not a fork when it is carried; Cargo stacking without a fork; A fork may damage the cargo without a fork. Exceed the nominal load of the forklift or the quality of the cargo. When the goods are easily broken, valuables or loaded with unstable goods, or when the goods exceed the height of the portal, the safety ropes shall be bound and the special persons shall be guided when necessary. When two forklifts unload the same cargo at the same time, they should be in contact. When taking the goods at the platform, the fork can only be taken from the platform. There should be some safety precautions when crossing the cross.
